JBOD Connection Interface | SAS |
Drive Bay | 12 x 3.5-inch |
Drive Compatibility | 3.5-inch bays: 3.5-inch SAS 12Gb/s, 6Gb/s hard disk drives 3.5-inch SATA 6Gb/s, 3Gb/s hard disk drives 2.5-inch SATA 6Gb/s, 3Gb/s solid state drives You can only use one disk type (HDD or SSD) in a RAID group. Combining different types of disk in one RAID group is not supported. |
Hot-swappable | |
Form Factor | 2U Rackmount |
Host Interface | Three SAS 12Gbps 4x wide port |
LED Indicators | Front panel: Status, fault, system over heat, fan error Rear panel: SAS link, SAS error, enclosure ID |
Buttons | Power Button |
Dimensions (HxWxD) | 88 × 439 × 520 mm |
Weight (Net) | 14.8 kg |
Weight (Gross) | 21.99 kg |
Operating Temperature | 0 - 40 °C (32°F - 104°F) |
Storage Temperature | 20 - 70°C (-4°F - 158°F) |
Relative Humidity | 5-95% RH non-condensing, wet bulb: 27˚C (80.6˚F) |
Power Supply Unit | Redundant/ Hot Swap ATX Power Supply, 400W, 90- 264Vac~, 47-63Hz |
Power Consumption: Operating Mode, Typical | 162.47 W Tested with drives fully populated. |
System Warning | Buzzer |
QTS / QuTS hero | |
Supports JBOD cascading | |
Standard Warranty | 3 |
Management | Managed via QNAP QTS OS 1. Supports disk S.M.A.R.T. information 2. RAID expansion enclosure identifier 3. Locate RAID expansion enclosures 4. Locate hard disks on RAID expansion enclosure 5. Smart fan control by detecting system and hard drive temperature 6. In-band SAS firmware update |